Vogue 8940: Mens Peacoat

I've never sewn for my husband, he's very much a jeans and t-shirts man. However he doesn't have any coats and when I saw the new Vogue patterns I scooped this one up. It's a nice simple peacoat with some cool details.

The fabric is a navy coating I picked up from Spotlight on clearance. It's very soft and sewed up beautifully, the colour is true in the top 4 photos (the detail pics are a bit washed out looking). Lining is Sunsilky from Lincraft and the buttons were from there too.

I followed the instructions all the way through (for once!), they are very similar to the RTW sewalong with interfacing on the front, side, back yoke, collars and facings. The lining is semi-bagged with the hems being hand sewn. I actually enjoyed the control this gave me over how well it all fit together. It has inseam pockets at the front and a welt pocket inside.

I'm still disappointed in the inside welt pocket. I managed to sew the welts on the wrong way around and had already cut the slit in the facing before I realised.......plus I didn't have enough fabric to recut the front facing and of course Spotlight had sold out of it. So it was carefully unpicked and resewn but you can see some pulling in the lining and its a bit uneven so I'm still not showing any close ups, lets look at the nice notched collar instead!

Fit wise I cut a sz42 which matched his measurements. I muslined it up and had to add width in the arms and the upper back. I remuslined all the changes and then cut the main fabric. Once it was sewn up I got him to try it on and it was massive so it was all unpicked and recut smaller. The final product is a sz 42 with a 2" broad back adjustment and a 2" bicep width adjustment. The chest and length are all straight from the pattern and fit him fine (he's 5'11"). If/when I make it again I'll be adding a little to the forearms and to the pocket opening width (I always tell him he has bear paws not hands so the pocket openings are a bit too small)

Each time I do a decent size broad back measurement I usually gather the back shoulder seam and ease it into the front, this tends to make the upper back creep forward at the back of the arms. Because this jacket also has a dropped front shoulder seam it seemed to exaggerate this so I put in a topstitched pleat instead of the gathers which made it sit a lot nicer (pleated is on the left, gathered is on the right)

I did flat piping around the facings. I'd been given a big bag of my hubbies late Grandfathers ties so I used one of them to make bias strips out of for the piping. This worked really well and there was enough fabric in the tie to make the piping and the welts for the inside pocket.

Speaking of the facing, the pattern doesn't include a back facing so I drafted one. It also doesn't include a jump pleat in the back lining. Not sure if this is normal in men's jackets?? I added a 1" jump pleat anyway.

I did notice the pattern asks you to cut 2 inside pocket lining pieces but you only need one (only mistake I found in the pattern).

All in all, I'm really happy with it. I wanted it to look casual but neat and I think it does, best of all it fits him and he likes it!